Megane UCH - Early S108502610 E Type

[mark]

Repaired or Replaced..

Renault Megane UCH from early models, slightly smaller but thicker packed unit.

Codes such as:
7703297929
S108502300

8200029342 B
S108502610 E

8200029342 B
S108502610 F

Common failure is water ingress, faults in locking, indicators, electric windows, etc

This part is a coded unit, and cannot be transferred to another vehicle without first being reprogrammed to factory coding or code transferred from the original unit.

Memory containment is stored in a Motorola Freescale micro-controller HC705B16 MCU.

1. We can supply these units pre-coded from your original units, ready to plug in and work, no need for coding! ..No visit to the Renault Main stealers required.
2. We can also supply these units Programmed back to factory default (Virgin). -Requires a Renault CLIP Diagnostic tool to code into the car and configure.

Images of board type attached.

Kind Regards
Mark
The ChipGods

(+44) 0121 288 58 44
(+44) 07535 115 115
Cannock, Staffordshire.

[racin-snake]

maybe of some help

[mark]

Pin outs are always useful :-D thanks

[asliyucegsm]

thank you friend

[pedrodiaz]

Repaired or Replaced..

Renault Megane UCH from early models, slightly smaller but thicker packed unit.

Codes such as:
7703297929
S108502300

8200029342 B
S108502610 E

8200029342 B
S108502610 F

Common failure is water ingress, faults in locking, indicators, electric windows, etc

This part is a coded unit, and cannot be transferred to another vehicle without first being reprogrammed to factory coding or code transferred from the original unit.

Memory containment is stored in a Motorola Freescale micro-controller HC705B16 MCU.

1. We can supply these units pre-coded from your original units, ready to plug in and work, no need for coding! ..No visit to the Renault Main stealers required.
2. We can also supply these units Programmed back to factory default (Virgin). -Requires a Renault CLIP Diagnostic tool to code into the car and configure.

Images of board type attached.

Kind Regards
Mark
The ChipGods

(+44) 0121 288 58 44
(+44) 07535 115 115
Cannock, Staffordshire.

Hello!

If i replace the HC705B16, of UCH bad to the UCH good, the car run?

Thaks!

[mark]

You MUST match the Siemens Sxxxxxxxx number, if not, it can have problems, as each 705B32 MCU is coded differently.

Providing you have a match, and the MCU is not water damaged, you can change it to the replacement UCH yes and the car start :-)